Thingiverse
Doweling Jig
von CaptainObvious
1.9k
Downloads
1.1k
Likes
3
Makes
A doweling jig for 8mm dowels with 50mm spacing between holes, the clamps (print two) can be used to center it on or along the edge of a board.
If you remove the clamps you can use the slots on the sides to align the jig to dowels that are already in place.
It needs six 8x22x7 bearings (standard skateboard bearins) and at least four M4 screws and nuts for the clamps.
If you remove the clamps you can use the slots on the sides to align the jig to dowels that are already in place.
It needs six 8x22x7 bearings (standard skateboard bearins) and at least four M4 screws and nuts for the clamps.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
