Thingiverse
Doweling Jig
door TheSameNameTwice
134
Downloads
76
Likes
0
Makes
Assembly:
1. Slide dovetail into main body with the locating notch going in first
2. Superglue the fence to the dovetail (be sure to not use too much superglue that it glues the dovetail into the main body).
3. Superglue knob onto hex head of 5mm x 8mm bolt and glue the washer down the bolt to the knob.
4. Remove dovetail from main body slot and screw in 5mm x 8mm hex bolt (you may have to tap the hole to make this more smooth, I suggest it).
Depending on your printer, you may need to ream the 5/16in holes to ensure the bit fits.
1. Slide dovetail into main body with the locating notch going in first
2. Superglue the fence to the dovetail (be sure to not use too much superglue that it glues the dovetail into the main body).
3. Superglue knob onto hex head of 5mm x 8mm bolt and glue the washer down the bolt to the knob.
4. Remove dovetail from main body slot and screw in 5mm x 8mm hex bolt (you may have to tap the hole to make this more smooth, I suggest it).
Depending on your printer, you may need to ream the 5/16in holes to ensure the bit fits.
TheSameNameTwice publiceert ook op
88 extra modellen op 2 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!