Thingiverse
Down with Trump
door urbanachiever91
53
Downloads
76
Likes
0
Makes
This was a birthday present I designed and printed for my dad.
I ended up printing the trump part at 115% and the base at 116% which resulted in a snug fit between the two pieces. No support required, used 15% infill but could probably get away with less given the right amount of top layers.
I ended up printing the trump part at 115% and the base at 116% which resulted in a snug fit between the two pieces. No support required, used 15% infill but could probably get away with less given the right amount of top layers.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!