MakerWorld

Vehicles

Down4Sound JP95T 1" Amplifier Riser

par grumpypants · Vehicles

64 Téléchargements

33 Likes

22 Makes

I needed to mount my Down4sound JP95 amplifier in my Durango, and didn't have anything good to space it off of the mounting surface, so I made some 1" amp risers. This should help with cooling quite a bit, due to allowing the fan on the bottom room to get cool air, reducing the likelihood of heat soak. The last photo contains some generalized instructions, but it's pretty straightforward. #8 screws are a little less bitey than #10 screws, but #10 are very tight. play around with your mounting hardware etc to your liking. I used bambu's new PETG-HF to print these, and would recommend at least that, or ABS, if you live anywhere hot. Enjoy

down4sound d4s jp95 amp amplifier amp riser amplifier riser amplifier foot amp mount amplifier mount d4s jp d4s jp95 jp95 amp jp95 amplifier car audio

Catégorie

Vehicles

Source

MakerWorld

Publié

22.09.2024

Mis à jour

30.04.2026

Ce qu'il faut pour imprimer: Intermédiaire Confiance faible

Monobloc Visserie requise

Supports 1/3

Assemblage 0/3

Réglages 1/3

Taille du plateau 0/3

Post-traitement 1/3

Imprimante

FDM / FFF

Format de fichier

STL

Matériau

PLA, ABS, PETG

Post-traitement

Visserie

Logiciel

Cura, PrusaSlicer ou similaire

Pas encore d'évaluations

Pas encore de commentaires – soyez le premier !

Modèles similaires

6 Suggestions

Down4Sound JP95T 1" Amplifier Riser

Modèles similaires

Ajouter à la collection