Thingiverse
Downstem Ash Mesh Holder
door 8xphoenix8
1
Downloads
1
Likes
0
Makes
A holder for a 21mm pipe screen, designed for a 14mm downstem, it takes two m3 10mm screws.
Ignore the dirty bowl, I was too lazy to clean it just to take photos after testing
My settings
15% concentric gyroid Infill
.12mm Layer height
Supports On
2 walls
4mm brim
Ignore the dirty bowl, I was too lazy to clean it just to take photos after testing
My settings
15% concentric gyroid Infill
.12mm Layer height
Supports On
2 walls
4mm brim
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
