DPS 5015 Case Slanted

I purchased a DPS5015 and needed a case for it, so I remixed zhuliang's box. The _slanted_ display was inspired by the Control box for the Wanhao Duplicator I3 V2.1 (3D printer).

I printed with 15% infill, but next time I'll do 25% since some filament fell (slightly) into the gaps.

*BEWARE*, the Banana jack holes on the left side are larger than the ones on the right. I had to wrap some tape around my banana plugs and epoxy them in place to make them fit. The integrated circuit board standoffs are too fragile when printed with 15% infill. I ended up having to glue one back on.

I designed [a lid to fit this](https://www.tinkercad.com/things/kiRVCgJmiH3-dps5015-cover/). The rear holes line up great, but the front ones are about 1/2mm off. The lid has a friction fit, so I don't feel it needs screws. Feel free to copy and [edit the model on Tinkercad](https://www.tinkercad.com/things/iZwlUeeMODr)