Slicer Discord
DPS5005 power supply case – Modèle 3D imprimable de Thingiverse Thingiverse
DPS5005 power supply case – Bild 1 DPS5005 power supply case – Bild 2 DPS5005 power supply case – Bild 3 DPS5005 power supply case – Bild 4 DPS5005 power supply case – Bild 5 DPS5005 power supply case – Bild 6
Electronics

DPS5005 power supply case

85 Téléchargements
88 Likes
0 Makes
Voir le modèle
Another case version of the DPS5005 module.

As the power supply I used for this is large and loud (48V/5A Meanwell with fans) it has to go under my desk. I wanted to be able to switch that on/off through the "control panel" on the desk. For this the mains power is going to the switch in the desk unit first, then to the Meanwell PSU.
The solution includes a 5cm fan with temperature control, powered by a HiLink power brick for mains to 12V.

Includes rubber feet to be printed in flex material like Ninjaflex.

The screw holes of the body are intended for 4mm melt-in nuts with 3mm thread, but you can use short 4mm screws as well (though the thread will wear out open/closing the case more often). Use 3mm screws and regular nuts for the rubber feet.
The thread holes in the back wall are intended to be screwed in directly with 3mm screws.
Use standard banana plug sockets for front and back.
The power sockets/plugs are "Bachmann 917.170 Kaltgerätestecker" (plug = input) and "Bachman
Catégorie
Electronics
Source
Thingiverse
Publié
Ce qu'il faut pour imprimer: Intermédiaire Confiance faible
Monobloc Visserie requise
Supports 1/3
Assemblage 0/3
Réglages 1/3
Taille du plateau 0/3
Post-traitement 1/3
Imprimante
FDM / FFF
Format de fichier
STL
Matériau
Post-traitement
Visserie
Logiciel
Cura, PrusaSlicer ou similaire
Pas encore d'évaluations
Pas encore de commentaires – soyez le premier !

Modèles similaires

6 Suggestions
Feed Blog Slicer Calculateur Recherche par image Soumettre Contact Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Ajouter à la collection