MakerWorld
Other Props & Cosplays
Ver Modelo
Dr Doom - The Ultimate Nullifier
7
Descargas
9
Likes
5
Makes
This is the Ultimate Nullifier inspired by Marvel Comics, The Fantastic Four, and Galactus. I designed it for one of my own cosplays, Dr Doom. It is split into 8 pieces that all connect together. I recommend using a small amount of glue to keep it together, but the tolerances are very tight. *2mmx50mm rod is recommended as reinforcement on the small end piece on the bottom as the long shaft will be a weak point as just a 3d print. The part is split in 2 and should be glued together after the insert is added.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
