Drag Chain Brackets for Ender 5 Plus

All brackets mount without the need to drill any holes in anything.

Brackets: Back row left to right.

X axis carriage bracket: Mounts on the bolts that hold the upper carriage wheels in place. Longer bolts are required: M5 x 40mm. Nylon washers are placed on the bolts between the nuts holding the wheels on and the bracket once placed on the bolts to take up any gap from the wheel nut to the back side of the bracket.

Y axis carriage lower bracket: Has slots to place M3 captive nuts and mounts to the underside of the Y axis carriage using M3 screws through existing holes in the carriage bracket. It is a close fit and the servo motor does not need to be removed to install this bracket.

Y axis carriage upper bracket: Mounts to X axis rail using 2 screws and T-nuts. Mounts snugly up against X axis servo motor cover.

Brackets: Front row left to right.

Y axis frame drag chain mount: Mounts to underside of rail using screws and T-nuts.

Y axis end stop bracket: You may have