Thingiverse
Dragon Air Plant
von mdelapa
17
Downloads
18
Likes
0
Makes
Added a base, and a 'vase' so that it could support a air plant.
I printed it in 0.15mm layer height, 10% infill no supports. Came out really nicely, although the dragons chin required a bit of sanding, slope was a little too steep at 80mm/s print speed.
Fits ~3cm diameter air plants.
I printed it in 0.15mm layer height, 10% infill no supports. Came out really nicely, although the dragons chin required a bit of sanding, slope was a little too steep at 80mm/s print speed.
Fits ~3cm diameter air plants.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
