MakerWorld
Sculptures
Model downloaden
Dragon Bust
39
Downloads
54
Likes
12
Makes
Hi guys, hope you like this new Dragon bust:) Feel free to scale it if you would like to print it bigger or smaller. I recommend to use pliers to carefully remove the support. I usually grab the support rather close to the connection, slightly wiggle it around to loosen it before pulling it off:) If you would like to sell prints of my models check out my commercial license on my Patreon or subscribe directly here on Makerworld: https://www.patreon.com/c/TreeDprintsAlso check out my other models here: https://makerworld.com/en/@TreeDprints
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
