Dragon_D&D

This is a remix of a dragon to use for D&D

"My first dragon" was a custom made project remixed from what was on thingiverse.
Made to be printable with the ender 3 in one piece. Remove supports yourself with soldering iron.

instructions:

Before starting; level your ender 3 printbed; gcode is attached; the lines should stick to the printbed, but the push should be little and the nozzle should not grind your bed to shreds; remove the lines before starting your print and reapply adhesive.

Day 01: print the dragon (9 hours on ender 3)
Day 02: print the D&D foot (make sure you print in the same size as the dragon or a bit bigger for a good fit. 5 hours 28min on ender 3)

(make sure your have a costume spool. The one on the top moves the printer too much. This might set off your printer and tip over the leggs.)

added a dungeons and dragons foot for the dragon.


(version 44: allot has happend since version 1. We wanted to reduce print time and reduce plate print time. Faster printing i