MyMiniFactory
Toys & Games
Zum Modell
Dragon Dragonfly Flexi
0
Downloads
0
Likes
0
Makes
Print Settings: Print in Place No Supports needed Arachne walls 2-3 walls 5-10% infill *.16 layer height if possible (.2 is fine, but the overhang of the underside of wing loop looks better at .16) If you have adhesion issues, try a brim, glue stick or Aquanet hairspray. I did also print these down to 70%- Your Milage May Vary ( I printed all sizes (70%, 85%, 100%) on the same multicolor plates with my usual settings).
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
