Thingiverse
Dragon Egg Lamp
por Ri0m0
180
Descargas
135
Likes
1
Makes
Hey, I'm glad you found my Dragon Egg Lamp.
You will need to buy a lamp socket and a bulb to assemble this.
EU Plug:
https://ebay.us/PRcPvm
US Plug:
https://ebay.us/hBRN1i
Enhance the ambiance with the perfect bulb:
EU:
https://ebay.us/yB4Acp
US:
https://ebay.us/oTWuS1
Print Settings:
You need the Egg and the holder, to assemble them like you can see in the last picture.
Egg: Use a 0.4 mm Nozzle! or a line height of 0.2 mm and a width of 0.4 mm.
Domes are quite hard to print. I always slow down the layers at the top to 50% print speed (at layer 670).
Use 100% infill with concentric infill, or set your wall count to something ridiculous like 40.
Any Basic white PLA will do the job just fine. I used Sunlu White PLA+ if that helps. Don't try Matte or glitter stuff, it will not work.
I use a brim of 10 lines to get this to stick.
It prints 16 hours for me. Be patient. The nose usually scrapes the print at some point but that's kinda normal. This happens beca
You will need to buy a lamp socket and a bulb to assemble this.
EU Plug:
https://ebay.us/PRcPvm
US Plug:
https://ebay.us/hBRN1i
Enhance the ambiance with the perfect bulb:
EU:
https://ebay.us/yB4Acp
US:
https://ebay.us/oTWuS1
Print Settings:
You need the Egg and the holder, to assemble them like you can see in the last picture.
Egg: Use a 0.4 mm Nozzle! or a line height of 0.2 mm and a width of 0.4 mm.
Domes are quite hard to print. I always slow down the layers at the top to 50% print speed (at layer 670).
Use 100% infill with concentric infill, or set your wall count to something ridiculous like 40.
Any Basic white PLA will do the job just fine. I used Sunlu White PLA+ if that helps. Don't try Matte or glitter stuff, it will not work.
I use a brim of 10 lines to get this to stick.
It prints 16 hours for me. Be patient. The nose usually scrapes the print at some point but that's kinda normal. This happens beca
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
