Slicer Discord
Dragon Illusion HueForge – 3D-printbaar model van MakerWorld MakerWorld
2D Art

Dragon Illusion HueForge

door AJAX3D · 2D Art
1.9k Downloads
702 Likes
416 Makes
Model downloaden
This model was created using the original art found here Dragon-Illusion-BBC (thinkfun.com). Once printed, I heated the print along the marked lines with a heat gun that was set to 220c (if printed in anything other than ABS you may need to lower this temp). Once the plastic was soft, I folded the plastic to the correct position (may require some adjusting) I then put a little super glue on the three folded tabs. On it's own, this does not stand up too well. I just placed a little double sided tape under the tail and stuck to the table. You could easily super glue the tail down to a printed platform. FoldingWhere it says "Mountain Fold" this is referring to the side you view the dragon from. See image below to help identify the correct direction of the folds. See the IllusionView from about 2 ftClose one eyeLook into the eyes of the dragonRock back and forth. WOW! Print SettingsPrint at 100% infill with a layer height of 0.04mm with a base layer of 0.16mmFilaments Used:ABS
Categorie
2D Art
Bron
MakerWorld
Gepubliceerd
Bijgewerkt
Wat je nodig hebt om te printen: Gemiddeld Lage betrouwbaarheid
Waarom?
supports nodig · uitgebreide nabewerking
Eendelig Supports vereist
Supports 2/3
Montage 0/3
Instellingen 1/3
Bedgrootte 0/3
Nabewerking 2/3
Printer
FDM / FFF
Bestandsformaat
STL
Materiaal
PLA, ABS
Nabewerking
Schilderen, Lijmen
Software
Cura, PrusaSlicer of vergelijkbaar
Nog geen beoordelingen
Nog geen reacties – wees de eerste!

Vergelijkbare modellen

6 Suggesties
Feed Blog Slicer Kostenrekenmachine Zoeken op afbeelding Indienen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Toevoegen aan collectie