Dragon Kin 2

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mmThe Model is 200x200mm in size. You can change X and Y but Z must remain the same.You may print at higher layer heights below the Min Depth of 0.48mmActual Depth is 4.5mm Filaments Used:PLA BambuLab Basic Black Transmission Distance: 0.6PLA BambuLab Basic Green Transmission Distance: 2PLA BambuLab Basic Yellow Transmission Distance: 6PLA BambuLab Basic Blue Gray Transmission Distance: 3PLA BambuLab Basic Silver Transmission Distance: 0.5PLA BambuLab Basic Jade White Transmission Distance: 5This print uses 6 unique filaments. Substitute as needed. Swap Instructions:Start with BlackAt layer #11 (0.96mm) swap to GreenAt layer #19 (1.6mm) swap to YellowAt layer #29 (2.4mm) swap to BlackAt layer #34 (2.8mm) swap to Blue GrayAt layer #43 (3.52mm) swap to SilverAt layer #50 (4.08mm) swap to Jade White for the rest.Boost MeGot a Boost to spare? Every little bit helps the motivation. Thank you!MembershipWant to go com