Dragon Kin

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm  The Model is 200x200mm in size. You can change X and Y but Z must remain the same.  You may print at higher layer heights below the Min Depth of 0.48mm  Actual Depth is 4.5mm Filaments Used: PLA BambuLab Basic Black Transmission Distance: 0.6 PLA BambuLab Basic Green Transmission Distance: 2 PLA BambuLab Basic Yellow Transmission Distance: 6 PLA BambuLab Matte Ice Blue Transmission Distance: 3.5 PLA BambuLab Basic Blue Gray Transmission Distance: 3 PLA BambuLab Basic Silver Transmission Distance: 0.5 PLA BambuLab Basic Jade White Transmission Distance: 5 This print uses 7 unique filaments. Substitute as needed. Swap Instructions: Start with Black At layer #11 (0.96mm) swap to Green At layer #14 (1.2mm) swap to Yellow At layer #19 (1.6mm) swap to Ice Blue At layer #29 (2.4mm) swap to Black At layer #36 (2.96mm) swap to Blue Gray At layer #42 (3.44mm) swap to Silver At layer #46 (3.76mm) swap to Jade White for the rest.