Thingiverse
Dragon Knob
por lceDog
2
Descargas
0
Likes
1
Makes
This is a knob for a windup toy. The knob is for a .100" square shaft, and fits inside a Ø.350" hole.
The bottom of the square hole is equal to the last 3 digits listed in the filename. (Adding spaces or tabs didn't work to line up the columns so I used dots to line them up).
Width at bottom of hole.......... Width at Top of Hole
094 ........................................ .107
104.......................................... .117
114 ......................................... .127
The bottom of the square hole is equal to the last 3 digits listed in the filename. (Adding spaces or tabs didn't work to line up the columns so I used dots to line them up).
Width at bottom of hole.......... Width at Top of Hole
094 ........................................ .107
104.......................................... .117
114 ......................................... .127
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
