Dragon Pose

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm  The Model is 200x200mm in size. You can change X and Y but Z must stay the same.  You may print at higher layer heights below the Min Depth of 0.48mm  Actual Depth is 2.2mm Filaments Used: PLA BambuLab Basic Red Transmission Distance: 4 PLA BambuLab Basic Orange Transmission Distance: 5 PLA BambuLab Basic Yellow Transmission Distance: 6 PLA BambuLab Basic Black Transmission Distance: 0.3 PLA BambuLab Basic Blue Gray Transmission Distance: 3 PLA BambuLab Basic Dark Brown Transmission Distance: 2 PLA BambuLab Basic Beige Transmission Distance: 8 PLA BambuLab Basic White Transmission Distance: 5 This print uses 8 unique filaments. Substitute as needed. Swap Instructions: Start with Red At layer #8 (0.72mm) swap to Orange At layer #11 (0.96mm) swap to Yellow At layer #13 (1.12mm) swap to Black At layer #19 (1.6mm) swap to Blue Gray At layer #20 (1.68mm) swap to Dark Brown At layer #22 (1.84mm) swap to Beige At layer #25 (2.08mm) swap to White for the rest.