MakerWorld
Sculptures
Ver Modelo
Dragon Skull
168
Descargas
152
Likes
78
Makes
Hi guys, hope you like this new Dragon skull:) Feel free to scale it if you would like to print it bigger or smaller. I recommend to use pliers to carefully remove the support. I usually grab the support rather close to the connection, slightly wiggle it around to loosen it before pulling it off:) There is a hole in the back for wall mounting this sculpture:) If you would like to sell prints of my models check out my commercial license my Patreon: https://www.patreon.com/c/TreeDprintsAlso check out my other models here: https://makerworld.com/en/@TreeDprints
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
