Thingiverse
Dragon wall hook with magnet mount
von CHayenga
42
Downloads
66
Likes
0
Makes
Filled hole and added a magnet to stick to the refrigerator to hang pot holders. The magnet I used for the 60# version is a GreatMag 60# weight capacity. Part# B07R8C4N43
I was having some issues finding consistent magnets so I upped the size of the magnet to 1.26 inches or 32 MM. I also added a shim because magnet heights vary between brands.
Made the model for the 60# version 190% larger and 215% larger for the 100# version to get the magnet to fit. Adjusting the model now would make the magnet not fit.
The 32mm version is very versatile, if the magnet isn't flush adjust the height of the shim to what is needed.
The 32mm is the one in the middle in the picture the other 2 are the smaller version.
I was having some issues finding consistent magnets so I upped the size of the magnet to 1.26 inches or 32 MM. I also added a shim because magnet heights vary between brands.
Made the model for the 60# version 190% larger and 215% larger for the 100# version to get the magnet to fit. Adjusting the model now would make the magnet not fit.
The 32mm version is very versatile, if the magnet isn't flush adjust the height of the shim to what is needed.
The 32mm is the one in the middle in the picture the other 2 are the smaller version.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!