Thingiverse
Dragons Teeth Tank Traps
von MojoBob
126
Downloads
60
Likes
0
Makes
Five simple bases for laying out lines of dragons teeth for wargames.
The teeth are designed for 15mm gaming, and are about 11mm tall. The base is very thin, just 0.4mm, and is intended to have flock and stuff glued to it.
To make them more sturdy, they could be glued to pieces of MDF or cardboard, but they probably wouldn't need it unless you expect them to get a bit of a hammering in use.
They can be printed at very low resolution — I print mine at a layer height of 0.3mm — as the layer lines look reasonably like cast concrete in scale, once they're painted and dry-brushed.
The teeth are designed for 15mm gaming, and are about 11mm tall. The base is very thin, just 0.4mm, and is intended to have flock and stuff glued to it.
To make them more sturdy, they could be glued to pieces of MDF or cardboard, but they probably wouldn't need it unless you expect them to get a bit of a hammering in use.
They can be printed at very low resolution — I print mine at a layer height of 0.3mm — as the layer lines look reasonably like cast concrete in scale, once they're painted and dry-brushed.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
