Thingiverse
Drain Cap
von Flavelius
96
Downloads
75
Likes
0
Makes
*3.9cm diameter*
*6.7cm height*
The top part has a small indented ring (about *1.5mm depth*) to hold a rubber band.
(The preview picture piece was printed with the Anet A8 as a replacement for a broken one, mostly standard settings and 10% infill which seemed to be enough)
.blend source file is included
*6.7cm height*
The top part has a small indented ring (about *1.5mm depth*) to hold a rubber band.
(The preview picture piece was printed with the Anet A8 as a replacement for a broken one, mostly standard settings and 10% infill which seemed to be enough)
.blend source file is included
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
