Thingiverse
Drain pipe connector
von ChrCphDk
0
Downloads
0
Likes
0
Makes
Needed a connector between two drain pipes.
This actually turned out to be too wide, leaving approx. 1 mm of free space to one side of the pipe. So if you decide to use this, print a test print sliced to just a few mm, and then scale it according to how that works on your pipe, or modify the included Fusion 360 model
This actually turned out to be too wide, leaving approx. 1 mm of free space to one side of the pipe. So if you decide to use this, print a test print sliced to just a few mm, and then scale it according to how that works on your pipe, or modify the included Fusion 360 model
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
