draw base clip

no supports no raft just print. i have used ABS without a problem.
this little clip goes under the bottom of the draw to keep the plywood base falling out (you know how you put too much weight in the draw and the bottom at the front come out. just turn the draw upside down slot the small piece in the draw front along with the draw base and use a small wood screw to hold it in place).
All the hardware you need is a small tack sized wood screw to hold it in place.
I found the best way to use them was two together both either side just off center.
they are a great fix for the loose bottom of a draw.

made with Tinker cad.
Seen this type along time ago but couldn't find any when i needed them so made my own..
Enjoy.