DrawBridge Extended

I increased the overall length by a few mm because I had some floppy drives that were slightly longer than others.

Also added a small bracket to provide back pressure when plugging in the USB cable to an FTDI board. The location works when using an Arduino Pro mini and an FTDI board joined inline - see photo of parts loosely fit into case. For the final assembly I use some thin foam (available in the craft area of most dollar stores) to pad the boards while centering the USB mini connector on the FTDI board in the small opening. Once everything is aligned I use some tape to hold things in place while I apply a few dabs of hot melt glue to keep everything in place but allow for easy disassembly in case of repairs. Another piece of foam on top keeps the contacts on the small boards from shorting on the floppy drive case.