Thingiverse
Drawer Divider
von helmar74
154
Downloads
190
Likes
2
Makes
A make would be highly appreciated
I created two “versions” with different sizes:
120x55mm
355x55mm
120x70mm
355x70mm
The connector is 2mm higher than the original one.
If you use the connector cut off a little piece on the end of each divider to make it smaller.
I created two “versions” with different sizes:
120x55mm
355x55mm
120x70mm
355x70mm
The connector is 2mm higher than the original one.
If you use the connector cut off a little piece on the end of each divider to make it smaller.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
