Thingiverse
Drawer Slide Mounting Bracket
door dkcwenge
0
Downloads
0
Likes
0
Makes
They are a rip off to buy, so just print these out instead!
I used PETG, but you can do PLA. Mine worked great at 15% infill, but I also used 0.55mm layers. Takes about 40 minutes for each bracket.
I used PETG, but you can do PLA. Mine worked great at 15% infill, but I also used 0.55mm layers. Takes about 40 minutes for each bracket.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
