Drawer Slide

I had a parts drawer that didn't slide right. When I dismantled things, I found the cause was a broken plastic piece, screwed to the back wall of the drawer, which should have supported the back of the drawer from an over head rail, shaped like an I beam.

The hardware store had some replacement ones which came as two pieces, which were supposed to adapt to a range of sizes, but this solution didn't last long.

I found a couple of similar parts on thingiverse but neither were the right size for my installation.

So I designed my own using the unbroken slider from one of the other drawers in this set, as a model. Here it is. Hope it is useful to someone.

Cheers,

Brian H.
Uxbridge Ont