Thingiverse
Dreamer's guide
von DK7
11
Downloads
2
Likes
0
Makes
Filament guide for large spools in FF Dreamer.
Prevents filament's "escape" from the spool.
Just push it inside existing recess as shown on the picture.
Small supports will be needed inside holes and slots.
You can probably print it out of any filament, but I've used ABS.
Prevents filament's "escape" from the spool.
Just push it inside existing recess as shown on the picture.
Small supports will be needed inside holes and slots.
You can probably print it out of any filament, but I've used ABS.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
