Dreamer spool holder adapter

An adapter for the original Dreamer spool holder (for those who do not like to throw away usable stuff). This adapter was designed for the right side, but its mirror should, in theory, work for the left side as well. The maximum size of the spool is 200mm in diameter (maximum of 65 mm in width). The hole in the middle of my spools is approximately 53mm in diameter. This adapter is a work in progress and has only been tested for the spools I currently use.

The installation is pretty simple. Remove the original holder, screw the adapter to the bottom of the holder and tighten it well. Screw the whole thing back to the printer with the original bolts.

You will also need two additional M3 20mm screws, to attach the adapter to the stand.

The spacer for the original rod was designed for my current filament spools. So I would recommend using BaronWilliams Omni stand rod and spacers for now.

Additional requirements:
2 M3 20mm screws with nuts