Thingiverse
Dremel 3000 Router Table Plug
von NJ_v_N
192
Downloads
152
Likes
0
Makes
A fitting designed so that I could use a piece of 20mm board as a makeshift small router table.
Thread is M19x2
Requires a 22mm hole drilled in the board.
I epoxied the fitting into the board which worked relatively well.
Thread is M19x2
Requires a 22mm hole drilled in the board.
I epoxied the fitting into the board which worked relatively well.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!