Thingiverse
Dremel 3D extender shaft
von bansheeman
12
Downloads
12
Likes
0
Makes
When using non standard PLA rolls on Dremel Idea builder, the material shaft is too short. This little file will allow you to use larger rolls without a problem.
There is a slight clearance from the standard platform.
Builds in 2 parts and assembly is super easy.
There is a slight clearance from the standard platform.
Builds in 2 parts and assembly is super easy.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!