Thingiverse
Dremel adjustable height router
door hudejo
25
Downloads
16
Likes
0
Makes
A Dremel 3000/4000 series plunge router attachment. Fully 3D printed.
How to use:
1. Screw in the inner part to your dremel
2. Screw the outer part to the inner. You can adjust its height by not screwing it in fully.
You can break out the small window holders on the left & right side so you can screw/unscrew bits with this attached.
Feel free to adit the source for very long/short bits (I'm using it with the no. 194 bit).
How to use:
1. Screw in the inner part to your dremel
2. Screw the outer part to the inner. You can adjust its height by not screwing it in fully.
You can break out the small window holders on the left & right side so you can screw/unscrew bits with this attached.
Feel free to adit the source for very long/short bits (I'm using it with the no. 194 bit).
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
