Thingiverse
Dremel Bit Holder
von simonlewis962
106
Downloads
97
Likes
0
Makes
made this holder for Dremel bits, 3 layers, holds about 39 bits, hole diam is 4 mm, dremel shaft is 3.17 mm
print on it's back as no support needed then
other bits and pieces coming for dremel just haven't the time at the minute to design them
.2 layer
and 20% infill
print on it's back as no support needed then
other bits and pieces coming for dremel just haven't the time at the minute to design them
.2 layer
and 20% infill
simonlewis962 veröffentlicht auch auf
3 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
