Thingiverse
Dremel Flex Shaft Driver Cap Nut
von jpnurro
58
Downloads
29
Likes
1
Makes
The Spare Dremel Driver Cap Nut for 225 Flex Shaft, 575 Angle Drive & 670 Saw
The thread in this one is .28x40 in
At least on my unit this a quite tight fit.
Some sources indicate the thread size M8x0.75, which might be correct but and indeed turns nicely. Is this application this one is too weak to resist the torque of the tool.
Seems that many printers (like mine) make inside holes 0.5mm too small. There for the shaft coupling is drawn a bit oversize.
The thread in this one is .28x40 in
At least on my unit this a quite tight fit.
Some sources indicate the thread size M8x0.75, which might be correct but and indeed turns nicely. Is this application this one is too weak to resist the torque of the tool.
Seems that many printers (like mine) make inside holes 0.5mm too small. There for the shaft coupling is drawn a bit oversize.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
