Dremel Guide

This is a snap on guide for the Dremel 565 Multi-Purpose Cutting Kit. I designed this for use with plastic cutting/ trimming jigs. The collar at the bottom of the part allows you to follow the outside of your jig without the rotation of the bit melting the jig.(keep in mind that you need to account for the offset between the bit and the OD of the collar.)

Offset with standard 1/8" trim bits: 0.1375"
collar OD = 0.4"
collar height = 0.25"

It can be installed by pressing it on, but it can be tricky. It's much easier to install and remove by removing the center of the Dremel guide and using a pair of channel locks to compress the tongs.