Thingiverse
Dremel Nut
por Klave
28
Descargas
14
Likes
0
Makes
This is a nut that I can hand tighten to hold my Dremel in a jig.
It's a 3/4" 12 tpi thread nut that will clamp the Dremel to a 2mm thick plate. The hole in the plate is 19mm.
If you use a thicker plate then you should drill the hole 25mm so that the larger shoulder seats on the surface. My plate is 3.7mm thick and the recess is 2mm.
On my printer I printed it scaled 101% in the radial directions to make the fit slightly looser but 100% threaded on fine
Lay it on its front face to print
It's a 3/4" 12 tpi thread nut that will clamp the Dremel to a 2mm thick plate. The hole in the plate is 19mm.
If you use a thicker plate then you should drill the hole 25mm so that the larger shoulder seats on the surface. My plate is 3.7mm thick and the recess is 2mm.
On my printer I printed it scaled 101% in the radial directions to make the fit slightly looser but 100% threaded on fine
Lay it on its front face to print
Klave también publica en
83 modelos adicionales en 3 plataformas más
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
