Dresser drawer pull

This was created to replace a missing drawer pull on a vintage dresser.

Configurations currently available:

* 2 holes, 25.3mm apart, pre-threaded for (I think) M4 x 0.7
* 2 holes, 32mm apart, pre-threaded for M3 x 0.5

If you'd like a different thread/hole configuration, leave a comment or send me a message and I'll get it added for you.

For best results, print with the back face (the side against the dresser drawer) down. The hole is pre-threaded, no need for tapping.

--

If you like my work and want to support me, please [check out my online store](https://shop.stephaniecervi.design) or [become a patron](https://www.patreon.com/stephaniecervidesign). Thank you!

--

Licensed for personal use only. [Commercial licenses available here](https://shop.stephaniecervi.design/pages/personal-commercial-licensing). Please do not redistribute this file or any modified derivatives of this file in any way, or sell your own prints made from this file. Thank you.