DRIED Spool Edge Tag for Bambu Spools

This is a remix of Sebastian's great Label field for Bambu Lab Spools one of the best fitting clips that stays inside the spool shape without exceeding outside the spool, so that you can still stack spools or shelve them side-by-side without losing space. A note about Bambu Lab spools: While most will find these clips fit perfectly with most of your spools, there are two WIDTHs of spools you may find, I don't yet know what the correlation is as all of mine have been re-used so many times I don't know what the original filament was, but for these instances, if you use a filament clip like Officina23's Dual Slot Low Profile clip, you can place the clip over it and it'll be a perfectly snug fit as shown below: This short version has the word DRIED as a modifier which you can remove or change to anything else. I do not recommend using this as a blank for labels, as 3 kinds of labels I tried on the side walls as these print, fall off after a few days. Because this happen