Slicer Discord
Drill Drum Sander – 3D-Druckmodell von MakerWorld MakerWorld
Other Tools

Drill Drum Sander

286 Downloads
232 Likes
114 Makes
Zum Modell
Drum sanding attachment for your powerdrill. External Hardware:2x 608 Bearing1x M8 nut1x M8 threaded Rod (90mm + Drumheight) Print Settings:0,2mm Layerheight, 4 perimeter, 20% Infill Assembly:Add 608 Bearing to the upperside of the handle (press fit)Ad 608 Bearing to the inside of the handle (press fit)Add M8 threaded rod to the drum. If it&#39;s too tight by hand use your powerdrill to thread it in. The rod should be 90mm + drum height in total length. If it&#39;s too loose or get loose during work, secure it with a little bit of superglue.Put the drumassembly into the handle. Make sure the side with the small circular extend faces the bearing.Add the M8 nut and tighten it. Now you can also put on the cap for the handle<img src="https://makerworld.bblmw.com/makerwor
Kategorie
Other Tools
Quelle
MakerWorld
Veröffentlicht
Aktualisiert
Was du zum Drucken brauchst: Mittel Niedrige Konfidenz
Warum?
aufwändige Nachbearbeitung
Einteilig Hardware nötig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 2/3
Drucker
FDM / FFF
Dateiformat
STL
Material
Wood PLA
Nachbearbeitung
Schleifen, Hardware
Software
Cura, PrusaSlicer o. Ä.
Gleicher Designer, mehr Plattformen

laisch veröffentlicht auch auf

23 zusätzliche Modelle auf 1 weiteren Plattformen

Verifiziert durch übereinstimmende Modelltitel über Plattformen hinweg.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen