Drill Holder

Hello everyone!

*edit: Printing tip: I used a high infill density, to make it a little heavy. I used 50% infill so it does not want to fall over easily. Other than that you can use any settings or filament you like, should work properly.

Another quick design, I used to have my drills in separate smaller containers, but it was a pain to get them out of it, so i decided to make an easy holder for them.

The holes that I created are attached in the picture, but to make it easier to read here they are from top row to bottom row, left to right:

8,2mm - 6,2mm - 5,2mm -- 8,2mm - 6,2mm - 5,2mm
2,2mm - 3,2mm - 4,2mm -- 2,2mm - 3,2mm - 4,2mm

Now you might ask, why is it ,2mm bigger? This accounts for printing error. the use for this item is to easily grab any drill, and I would not like to use both my hands to pull 1 drill out.

If any of your drills do not fit, do not worry! Just drill them out with the drill that needs to fit in it!