Thingiverse
drill holder
von Mareyota
13
Downloads
4
Likes
0
Makes
This thing was made with Tinkercad.
I made this cordless drill holder for my tool kart because it's the one tool I always use. But if I want to store it I have to put it back in the case it came in. And that isn't very handy if you use it every time. So I needed a holder right there so it's in reach
The square holes are 5.95mmX5.95mm and 6.2mm apart. A little trimming may be needed considering settings.
I made this cordless drill holder for my tool kart because it's the one tool I always use. But if I want to store it I have to put it back in the case it came in. And that isn't very handy if you use it every time. So I needed a holder right there so it's in reach
The square holes are 5.95mmX5.95mm and 6.2mm apart. A little trimming may be needed considering settings.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
