Thingiverse
Drill Press Pipe Holder/Guide
door Add_Em
1
Downloads
5
Likes
0
Makes
This is a cross-cut jig/holder for conduit, PVC, or any kind of pipe. It comes with a small insert that centers the jig on your drill press table. Once centered, you can clamp or screw the jig down to the table and hold a pipe with it. This jig allows you to drill perfect cross-cuts in pipes.
There are 2 sizes
Smaller: 7/64" - 3/4" drill bits
Bigger: 1/4" - 1 1/4" drill bits (centering insert works well with a 1/4" pilot drill bit)
Both sizes have a support piece for the other side of the pipe
Supports are recommended to make the centering insert smoother.
There are 2 sizes
Smaller: 7/64" - 3/4" drill bits
Bigger: 1/4" - 1 1/4" drill bits (centering insert works well with a 1/4" pilot drill bit)
Both sizes have a support piece for the other side of the pipe
Supports are recommended to make the centering insert smoother.
Add_Em publiceert ook op
8 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!