Thingiverse
Drillable Centrifugal Fan
por Bionicarm
12
Descargas
11
Likes
0
Makes
Trying to build a small blower for a moderate flow and pressure system. I've had good luck with straight vane blowers in the past so I tried out NamorIt model. Had to adjust it a bit to fix an issue with non concentric platform and to fill in the hole. I left a small hole in the middle to guide a drill bit allowing you to drill it out as needed. I'm a bit of a hybrid, I like to print parts and then adjust them to fit and add to another project.
If you set it down a bit in Cura you don't need supports, otherwise if you need the flanges on the back you can print with supports as normal.
If you set it down a bit in Cura you don't need supports, otherwise if you need the flanges on the back you can print with supports as normal.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
