Thingiverse
drink game - selector arrow
von heraldomedeiros
0
Downloads
1
Likes
2
Makes
inspired by Drink game spinning arrow by Matthijz98 (https://www.thingiverse.com/thing:2777445), but designed from scratch
6004Z bearing needed
also, some Cyanoacrylate glue may be used to unite top an bottom parts, although not needed
top part may require supports, not the other two
any hard material will be OK (PLA, PETG, ABS, Nylon...) mine is in PETG
any infill will also do (mine is 20%). just use 4 to 6 walls
no need to use a super resolution. I´ve printed mine in 0.3mm layers
Use it wisely :)
Please, share it if you print it!!!
6004Z bearing needed
also, some Cyanoacrylate glue may be used to unite top an bottom parts, although not needed
top part may require supports, not the other two
any hard material will be OK (PLA, PETG, ABS, Nylon...) mine is in PETG
any infill will also do (mine is 20%). just use 4 to 6 walls
no need to use a super resolution. I´ve printed mine in 0.3mm layers
Use it wisely :)
Please, share it if you print it!!!
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
