Thingiverse
Drip Tray
by SirFancalot
11
Downloads
3
Likes
0
Makes
A sturdy drip tray with a low profile in a hexagonal shape - 6mm tall with 3mm plate and supports. Even with PLA it won't bend if you spill a little hot water on it, just don't bathe it in boiling water ;-)
In order to print properly I left out feet for it. You can put some of those sticky felt pads on or maybe a silicone fish eye thing - that'll keep it steady on rocky ground - or print som crazy spidey legs for it and send me a picture :-D
Print with your favourite settings in your favourite material and enjoy a stain-free table.
I printed it with Extrudr crazy pla based bio copolyester, but that might be a bit excessive.
If you don't want to wait all night for a single one of these - give that .6 or .8mm nozzle a go ;-)
In order to print properly I left out feet for it. You can put some of those sticky felt pads on or maybe a silicone fish eye thing - that'll keep it steady on rocky ground - or print som crazy spidey legs for it and send me a picture :-D
Print with your favourite settings in your favourite material and enjoy a stain-free table.
I printed it with Extrudr crazy pla based bio copolyester, but that might be a bit excessive.
If you don't want to wait all night for a single one of these - give that .6 or .8mm nozzle a go ;-)
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
