Thingiverse

Drone frame

von GTE520

0 Downloads

0 Likes

0 Makes

Uses 6x4 mm CF tube, I used roll wrapped glossy CF, epoxied into 3d printed parts. Had a set of 2205 outrunners laying around hence the hole pattern on the motor mounts. CF length is set depending on anticipated prop size, I ended up using 8045 props. The board mount is printed out of TPU to accommodate a 30.5 x 30.5 mm AIO flight controller/speed control board. Motor mounts were printed out of PLA at 20% infill, make sure these are printed as hot as you can get it to avoid layer separation failure.

https://www.amazon.com/dp/B0CPY31H6S

https://www.amazon.com/dp/B0CPY31H6S