Thingiverse
Drone Helipad
di evacobalt10
7
Download
2
Likes
0
Makes
I decided to test my CAD skills and made this in fusion360. Feedback is welcome
This is a drone pad that folds and can stick into the ground to provide a nice flat surface to launch from. The pad was made on a sidewinderx1 and the legs were made on an ender3v2 all from PLA at 20 percent infill. You will need to print 2 Leg As and 2 Leg Bs as well as the actual pad itself.
Required materials:
4-M5x20 screws (can use m4x20 as well its just a little sloppy)
8-M5 washers
4-M5 nuts
This is a drone pad that folds and can stick into the ground to provide a nice flat surface to launch from. The pad was made on a sidewinderx1 and the legs were made on an ender3v2 all from PLA at 20 percent infill. You will need to print 2 Leg As and 2 Leg Bs as well as the actual pad itself.
Required materials:
4-M5x20 screws (can use m4x20 as well its just a little sloppy)
8-M5 washers
4-M5 nuts
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!