Thingiverse
Drone JD1
door creatorething
7
Downloads
8
Likes
0
Makes
This Drone was created to have a more reliable and versatile aircraft using the same motors than Syma X5 series or Tello.
You can strip your syma x5c and place all the eletronics inside this frame as it uses cable covers you don't even have to remove or soldering cables to the flicg controllers.
It also can be use with a 25x25mm Flight controller and 6mm brush motors.
The T2W ratio is 1.5:1 which is very good for a smooth flight. The gears has been removed from this iteration, it allows a nicer flight and also could get motors very hot, we recommend to use to use ABS but in PLA works very fine too. It fly really well.
The Blades are tello or similar.
Enjoy please post photos!
You can strip your syma x5c and place all the eletronics inside this frame as it uses cable covers you don't even have to remove or soldering cables to the flicg controllers.
It also can be use with a 25x25mm Flight controller and 6mm brush motors.
The T2W ratio is 1.5:1 which is very good for a smooth flight. The gears has been removed from this iteration, it allows a nicer flight and also could get motors very hot, we recommend to use to use ABS but in PLA works very fine too. It fly really well.
The Blades are tello or similar.
Enjoy please post photos!
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
